Instructions for OSC7.0: When the scope clock is plugged in, the blue led & the small led on the module should light immediately. Press the "slow set" button (immediately after power on) and hold for up to three seconds until the relay clicks and the neon bulb lights. The relay should click on, neon light should light, and in a few minutes the screen should display time. The display will go to run mode (clock face) or "Oscilloscope clocks" Press slow set button again to start, and use fast set & slow set to set the time. Toggle button will toggle the display on & off, just press once. For the quick start video please use the youtube link here: https://www.youtube.com/watch?v=oXqGBzmSzus&t=16s To connect the clock to your network via wifi, start from power on, unplug and wait a few minutes if it's already powered on. From power on (blue led & led on module lit), press & hold the "toggle" button for three seconds to enter AP mode. Use your device to look for the AP "WifiModule" on your networks. Connect to this AP, and when connected, open your browser and type "192.168.4.1" in the address bar. Enter your network name or SSID and your network password. Click "Submit" button and the confirmation page should appear. Within a few minutes, the clock should connect to the network and the neon bulb (high voltage) should light. If the clock doesn't connect after several minutes, try resetting the chip by pressing the miniature button on the ESP32 board marked "EN" or alternatively, just unplug the clock and wait a few minutes, then plug it back in and it should connect. The time should appear. If incorrect, press the "fast set" & "toggle" buttons simultaneously to refresh the time. To erase the network name & password, press and hold toggle button while powering the clock on, and release after three seconds. Wifi should go into AP mode, allowing connection to enter new credentials. From the clock face screen, press slow set & toggle simultaneously to display the day & date. From the date screen, press fast set to return to the time screen. From the date screen, press slow set & fast set simultaneously to enter the Menu screen. In the Menu screen, use fast set to select the line indicated by the arrow, and use slow set to change the selection. When the Menu settings are correct, press toggle once to exit and return to the clock face screen. From the clock face, press fast set & toggle simultaneously to refresh the time. To set the sleep/wake times, press fast set & slow set, and the screen will appear for setting the "on" time. Use fast set to choose the display on (wake) time (hours only). Press toggle once to enter the "off" time screen. Fast set to select the off time, and toggle once to exit to clock face screen. Please note that in order to program a PM "off" time, you will need to pass 12:00 to get into the PM hours. Time Zones : 1 = EST 2 = CST 3 = MST 4 = PST 5 = AKST 6 = HAST 7 = BST 8 = CEST 9 = MSK 10 = PHT 11 = ACST 12 = GST 13 = AEST